Maintenance for Bearings of Sawdust Pellet Mill

With the amazing features of high working efficiency, strong working capacity and long service life, sawdust pellet mill is regarded as the top choice to process the wastes of sawdust. According to the desired features of biomass pellets, you can adjust the water content and formula of raw materials.

If there are something wrong with the formula, you will confront the problems like low output and serious wear during the working process of saw dust pellet machine. If biomass pellets are used for feeding rabbits, grass powders in raw materials should not be higher than 50%. Then, water content in raw materials should be kept around the 20%.

After each run of saw dust pellet machine, you should clean it carefully. By doing so, you can prevent the raw materials from blocking the holes. What’s more, unnecessary wear of saw dust pellet mill can be well reduced. For every 200 hours, you should clean the bearings of sawdust pellet mill.

If bearings are seriously worn out or damaged, you should immediately change them with new ones and lubricate them with oil. If bearing used are in cone shape, you should often check the axial distance and make it around the 0.1-0.3mm. If distance is not in this scope, you can adjust it by increasing or decreasing the paper pad at the bearing cap.

Known as the NO.1 brand of sawdust pellet machine, FTM China Machinery will never forget its role to offer the best products and products for customers. Surprises for you on website!